I removed the board, it's quite difficult

[shapanqqcceqd]

The problem is that I have an Indesit washing machine and for no apparent reason the indicator panel started blinking, that is, the lights above the buttons and blinking very quickly, like a color music. I looked at the instructions, there is no such thing there, I went through all the error codes and found nothing

Apparently, the power supply unit in your washing machine, or more precisely in the control unit, has failed. Remove the control unit, if you have a horizontal loading washing machine, it is located in the lower left corner oman telegram data of your washing machine, if you look from behind, in the verticals at the top under the control panel. You will need to remove the module from the plastic box and inspect the containers for swelling. I think this will help you. Good luck

Thanks for the advice, I'll try it now. I had to unscrew the hatch at the back of the washing machine, it's attached with six screws and try to get it out of there, but nothing worked, I couldn't disconnect the wires. In the end, I put the machine on its side, on the side where the powder is poured in, although I flooded the floor with water, I had to drain the water from the washing machine first. In short, when I put it on its side, only then did I easily disconnect the wires. I wrote this to those who will remove the control module themselves. I just took the board out of the box and, in fact, two containers swelled up, now I'll remove them from the receiver and solder them here. I think I'll write about the result in an hour

A quick guy, I hadn't even managed to say "A" yet, and he had already disassembled the washing machine. Be careful not to mix up the polarity on these capacitors, it often happens that due to ignorance people install them in vain, as a result the indicator panel may burn out. Be careful.