Malfunction of the button on the hammer drill

[shapanqqcceqd]

Tool owners encounter a faulty button much more often, so everyone wants to know how to repair it. It is almost impossible to repair a power tool button, since it consists of contact plates and springs. If the button has a built-in board for adjusting the speed, then an electronic element on the board may burn out, which can be identified if you have experience in electrical engineering.If you have never held a soldering iron in your hands, then it is recommended to buy a new button for a hammer drill of the same type and replace it. You can buy a button of the appropriate size in the online store Cylinder, where there are many models for all types of power tools.

Only a multimeter can help check the button for serviceability. Usually, it is possible to detect a button malfunction without additional devices, since the trigger mechanism starts to jam, and the lock does not oman telegram data press. The reverse switch, which is usually located next to the power button, can also jam. If the reverse mechanism is faulty, it must also be replaced along with the switch.

This is interesting! If you want the button on the hammer drill to last a long time, you need to buy original models for the corresponding brands of power tools. You can find original buttons for hammer drills in the online store "Cylinder".

How to replace the brushes on a hammer drill when they wear out
The brush assembly in the hammer drill design ensures the transmission of electric current to the electric motor anchor, thereby setting it in motion.The brushes rub against the collector unit, and this causes them to wear out. They must be replaced immediately as soon as the following signs are detected:

Strong sparking, which can be detected through the ventilation grilles of the housing.